Phil's G.I. Joe Page


Wait... you're actually reading this?!
Sunday, July 28, 2002
 
Well, I finally finished Jedi Outcast today. (Ok, well, technically, yesterday, but who cares?) But the best news is I finally figured out how to get a double-bladed lightsaber in multiplayer mode! The trick is knowing the file name of the level. Pay attention when the level loads, because it gives the file name there. To get the lightsaber:

- Press Shift and ~ to open the console.
- Type devmap ***** (Where ***** is the name of the level, or everything before the .bsp of the file name for that level.)
- After the level loads again, equip your lightsaber. (Press 1.)
- Turn off the lightsaber. (Press 1 again.)
- Press Shift and ~ to open the console again.
- Type \thedestroyer to enable the double-bladed lightsaber.

If you did it right, your screen should "bounce" a little, the lightsaber should ignite, and the console will respond: THE DESTROYER COMETH.

posted by Phillip at 12:50 AM 0 comments
Comments: Post a Comment

 
This page is powered by Blogger. Isn't yours?

The views and opinions expressed here are solely those of Phillip Donnelly. Unless explicitly stated, all statements are those of Phillip Donnelly. So there!

Speak to me, people!
IM Me!

Get fonts for this page!